XBEE PROTEUS LIBRARY INSTALL

Step 6:-Р’В Choose the Product family of your device which is available on back of XBee module. We have to make it Coordinator for the transmitter part.Р”Р‡irst, update the Firmware by clicking on the Update firmware. As you can see, there is R showing on the left panel which means Xbee is in router mode. Use either AT commands or put the data manually. Step 5:-Р’В Now, you can configure your XBee module in this window. This process will add your XBee module to XCTU dashboard. Step 4:-Р’В Select the Discovered device and click on Add selected device. Step 3:-Р’В In the next window, set the USB port parameters as shown below and click on Finish.

Step 2:-Р’В Select the Serial port of the Explorer board/Arduino board and click on Next. In our case, it will show only one XBee module. This will show you all the RF devices connected with your laptop. Step 1:- Now, click on the search button. Check the COM port of the Arduino board in device manager. After downloading and installing the XCTU software, open it and make sure your XBee module is properly connected.

XBEE PROTEUS LIBRARY INSTALL

Here in this tutorial, a Explorer board is used to configure the XBee modules.Р”Вownload the XCTU software from this link and install it.

Vcc (Pin1) of Xbee -> 3.3v of Arduino board.

Gnd(pin10) of Xbee -> GND of Arduino board.

Rx(pin3) of Xbee -> Rx of Arduino board.

Tx (pin2)of XBee -> Tx of Arduino board.

Xbee proteus library